![<?echo $_SERVER['SERVER_NAME'];?>](/template/twentyseventeen/skin/images/header.jpg)
The generator of the LED outdoor mobile advertising vehicle is the main component of the whole vehicle, and the generator is a system device that can be used for power supply of the LED outdoor advertising vehicle. Unless it is when the LED outdoor advertising vehicle is plugged in with an external power cord to play advertisements and is parked at a certain point, the remaining time is required to use the power of the LED advertising vehicle generator to use. If there is no generator, then the entire car cannot be used. Therefore, special attention must be paid to the maintenance and the maintenance of the LED outdoor advertising vehicle generator. But how should the generators of LED outdoor advertising vehicles be maintained?
LED outdoor mobile advertising vehicle generator maintenance and maintenance are required to carry out regular inspections and maintenance, the most important part is the use of generator oil inspection, oil replacement should be diligent. When the LED advertising vehicle is stopped and the vehicle is not started for 2-30 minutes, take out the oil dipstick, wipe the dipstick with a paper towel or a clean cloth, and insert it into the oil hole again. Ten seconds are taken out, which can effectively guarantee that the oil can eat the highest mark on the oil dipstick and the upper part and the middle of the lowest mark.
Then, under careful inspection, how tight the LED outdoor outdoor advertising vehicle water pump belt is, if there is loose or too tight, it needs to be adjusted properly. LED outdoor mobile advertising vehicle generators use a closed water cooling system, so we also need to check the liquid level of the coolant to see if the liquid level can reach the standard scale. If there is a lack, you need to immediately Raise.
Then, for the inspection and maintenance of the air intake system of the generator of the LED outdoor mobile advertising vehicle, it is necessary to periodically perform the inspection in accordance with the conditions of use. Need to cherish the inspection from the position of the air inlet to the position where the intake manifold exits. Check if there is any damage to the air intake hose and whether the tightness of the snap ring is appropriate. If there is an abnormal situation needs to be replaced in a timely manner to avoid affecting the use of LED outdoor mobile advertising vehicles.
CNC Milling Parts,CNC Milling Service,CNC Machined Components,CNC Milling Machine Parts
Grand Nakamura Mechanical and Electrical (Suzhou) Co., Ltd. , https://www.gns-mp.com